steering wheel oil & trim noise (helppp)

[vectra_]

hi everyone, sometimes the traction controll light comes on while driving and stays there till i turn the car off and on again.....it started to happen really often..

also second problem is that theres alot of noise coming from the inside trim, for example when i go over speed bumps and stuff from the doors from the front theres a funny noise coming....and it really drives me mad... cant drive without the radio on...

Warning: This is an Old Thread This discussion is older than 120 days. information contained in it may no longer be current . Please think of the children before resurrecting this ancient thread!

[vectra_]

anyone :s

[guy 27]

for the tc light i can't really help. I suggest trying to see if there is any code stored which should point you in the right direction as to whats wrong.

for rattles in the car. every car will develop them in time. try finding out exactly where the noise is coming from. If its just trimming thats loose, make sure its in place correctly and either fit new clips or place some foam inbetween the 2 objects that cause the noise. can be a very painful process but it is fixable in most cases.

also why is there steering wheel oil in the title?

[vectra_]

oh, i thougt it might be that theres no oil left but i cant really check because its underneath the engine... :s

also with the noises, what i can tell you is that its not normal, because the noise comes from everywhere...from the doors from the back its just annoying..how do i fit new clips_ and where do i get them from??

and thanks for the reply (:

[guy 27]

there is a large reservoir for the steering fluid on the firewall. just check to see that its filled up to the full mark. if its leaking i am sure you would notice some spots on the ground where you park your car.

as for the clips, not sure on the sizing that the vectra uses. best option is to take the trims off (will be some screws and then it just pulls off) and count how many there are. might be more than 1 size so just take them to an auto store and just replace any you break. you can get them from holden but they will charge around $2 each for them.
its pretty much a trial and error process to eliminate rattles.

[vectra_]

couldnt find it on the firewall...

it is really hard to check the steering fluid...im lost. :s

[ChrisMaz]

Ahhh the rattles. I found the front trim its the tweeters (Front speakers) Don't think they've been secured very well. As for the back, no idea... Perhaps get your suspension (front and rear) checked if its rattling and bumping around.

As for the TC, If the traction control light is coming on whilst you are driving, and you havent selected to turn it off (CDXi?) then theres a fault with the TC. Get a diagnostic from a holden stealership or anyone with a tech 2 scanner.

Are you getting TC light on as well as car and spanner? Or is it TC and Steering light?

If the spanner comes on then you have some potentially major problems that need to be sorted quickly.
If the TC and Steering light come on, its most likely due to the CIM (Column integrated module) Which is the computer that sits behind the steering wheel housing the indicator, wiper stalks etc. This was a pretty common fault in a lot of the vectras and most were under warrenty. (Check your log book and see if anything is mentioned) You'll need to get a diagnostic to find if the CIM has failed eitherway.

Forgot to mention the obvious, disconnect the battery from the car for about 45-60 minutes and then see if that clears it. TC light coming on all the time could be as simple as a sensor failing or at worst, the whole TC/ABC module failed.

[vectra_]

yes its a cdxi...

you cant turn the traction control of..i mean when i push the button the traction light stays on, when i push the button again the traction light goes away BUT when a wheel starts to spin the traction light starts flashing...

the steering wheel problem is started to happen often, the traction light comes on and stay on and theres a steering wheel symbol with a ! sign..

[ChrisMaz]

Sounds exactly like a failed CIM mate. Does the steering get very heavy as well? If it is, its because the CIM controls the power steering.

[vectra_]

yes it does...it does get heavy... :s so what do i have to do