Siemens uses, at least at the MS4* series ecus, a separate area in the calibration file to set the axis descriptions. Its not as easy as at bosch ecu where the axis and mapsize can easily be found in front of the map. I´m working with TunerPro too, very nice software.Thermostat.jpg
which company did you contact? OLSX.be? Damos file will be ~300€, but its worth every cent if its the correct softwareversion you have.
Could you upload the file you´re working with? I had no luck downloading it at my girlfriends ecu and i´m really curious to take at look at it
Reply With Quote