Supercheap Auto Torque Wrench

[03srit]

I've got a kinchrome one that I bought when I installed my vxr turbo and it only goes to 10Nm aswell.. It's the 3/8 drive, deflecting beam type..

[boorny88]

both mine the lowest reading is like 50Nm i think but its been awhile since i used them

[Rhino]

I've got a 2-24 and 20 - 150 or something.

Would love a couple of Norbars.

[Wraith]

I'm replacing my rocker cover gasket again and need a Torque Wrench.

how are the Supercheap Auto Torque Wrench on sale for $49 http://www.supercheapauto.com.au/onl...214304#details

Am I wasting my time or should I just borrow someone's better quality one?

Yes, don't buy it - spend more and get a 'proper and accurate' one if your going to bother to select a torque setting for tightning bolts...otherwise you may as well do it the old fashioned way with any wrench tool...

I wouldn't get one.
A 'little amount' or not, I want to make sure it is accurate, it'll last, and that I'm not wasting my money.

You could go with a Kincrome (I have two), which is better, not too pricey and better supported.
I wound the handle out on one too far. I took it back and asked them to get it recalibrated for me - at my expense - I was happy to fess up to that one.
I was told to just grab a new one off the shelf.

But everyone is different. I like to try and be as accurate as I can. If they specify a torque setting, then it is important.

I think I read a post on here from someone, answering the question of "how much is 8Nm?"...
The response, "Hand tight". LMFAO.

+ 1 Agree

My Bro bought one not long ago ( I'm assuming but obviously not sure if it's the same as these on sale now) and after testing it out against one my cousin who's a mechanic uses, it's out by a long shot !!!

[Alix]

I bought the Kinchrome 1/4inch micrometer one from the big green shed a couple of weeks ago - was only $80, and came with a calibration test result (and a nice hard case to protect it when not in use). Worth the extra I think.

Only goes down to 13Nm though, so no good for this job. They had a 3/8in drive version too, which might be worth checking out the specs for.

[Shay]

john that one will be fine for what you need.