Supercheap Auto Torque Wrench

[JohnBu]

I'm replacing my rocker cover gasket again and need a Torque Wrench.

how are the Supercheap Auto Torque Wrench on sale for $49 http://www.supercheapauto.com.au/onl...214304#details

Am I wasting my time or should I just borrow someone's better quality one?

Warning: This is an Old Thread This discussion is older than 120 days. information contained in it may no longer be current . Please think of the children before resurrecting this ancient thread!

[Nurb608]

Can't see it being too bad, atleast for the little amount of torque required for what you are doing. If you were doing larger jobs i'd get a better one. Just check what the lowest torque setting is first though as some of them don't start until a bit higher than what you may need.

[JohnBu]

Good idea,

I'll check what torque the bolts require and what settings the wrench has.

[03srit]

For the rocker cover I think it's 8Nm and the torque wrench I bought from sca before only goes down to 13.6 Nm so make sure that one goes down to 8Nm..

[Rhino]

I wouldn't get one.
A 'little amount' or not, I want to make sure it is accurate, it'll last, and that I'm not wasting my money.

You could go with a Kincrome (I have two), which is better, not too pricey and better supported.
I wound the handle out on one too far. I took it back and asked them to get it recalibrated for me - at my expense - I was happy to fess up to that one.
I was told to just grab a new one off the shelf.

But everyone is different. I like to try and be as accurate as I can. If they specify a torque setting, then it is important.

I think I read a post on here from someone, answering the question of "how much is 8Nm?"...
The response, "Hand tight". LMFAO.

[03srit]

EDIT: just checked mine and it's the 1/2 drive so it's not the same as that one on the link..

Still check what the minimum is though..

[Nurb608]

Yeah, i use the kincrome one too

[JohnBu]

Maybe I'll borrow a decent one from someone as I'd doubt I'll use it frequently.

where is Steve when you need him

[JohnBu]

I'm pretty sure 8Nm is correct.

[boorny88]

i got two snap on torque wrenchs one electronic one i got give and a windie one i bought but neather go low enough for my cars torque specs so i will need to buy a 3/8 drive one when im back in the workshop to claim it haha