Access Points/Network Extenders

[gman]

It might stop the neighbours as the signal strength would drop and be to low of you aim it away from them.

But for two devices in the same space, if they are on the same band and competing with good signals then they would continue to interfere at the intended source of they are both in range... Maybe...

If you were aiming them in opposite directions and there was adequate distance for separation then it could possibly help I suppose....

[sooty]

It might stop the neighbours as the signal strength would drop and be to low of you aim it away from them.

But for two devices in the same space, if they are on the same band and competing with good signals then they would continue to interfere at the intended source of they are both in range... Maybe...

If you were aiming them in opposite directions and there was adequate distance for separation then it could possibly help I suppose....

Yeah that was the idea, putting the windsurfer on the tv sender, and pointing it towards where the rumpus room is (and the receiver, but nothing else) in the hope that then my room and the rest of the house (oppo direction) won't suffer too badly from interference.
Ahhh well...can always just try and see what it does

[gman]

Yeah that was the idea, putting the windsurfer on the tv sender, and pointing it towards where the rumpus room is (and the receiver, but nothing else) in the hope that then my room and the rest of the house (oppo direction) won't suffer too badly from interference.
Ahhh well...can always just try and see what it does

Can only give it a try mate...

[poita]

and here it is

results: in the loungeroom where i usually use it has gone from 50%-60% to 80%-100%
and the spot next to my tv where i was having problems 20%-30% to 60%-80%
syer has defin made a difference.
will keep an eye on it over the next few days jsut to make sure its that and not some freak of nature

[SSS_Hoon]

sweet.

But wouldnt haveing them behind eachother like that sort of counteract the first one as it would be bouncing back on itself.

What about turning the router on the side so u can have them both facing that way side by side instead of behind?

SSS_Hoon

[poita]

they dont fit together too well.

im thinkin of building one big one, that will take in both anntenas.

like i said, its just an experiment.
these where done on 8x12, so might do em on 6x8 and see if they fit any better

[HappySlapper82]

Have you taken the front one off to check your signal strength with just the one at the back? I would imagine that should work just as well

[hazrd]

sorry but i just cant help but to piss myself laughing at this because its so simple and it works so well!!

mines currently under construction too