Well it appears it wont start without the abs hooked up ! IT GOES !
Thanks again for all your help mate.
Printable View
Well it appears it wont start without the abs hooked up ! IT GOES !
Thanks again for all your help mate.
No problems. Nice work and I hope you enjoy the extra power over the old Z16.
Ok so back to a couple of issues, If anyone has any clues on these.
Sometimes first thing in the morning it wont start at all. Just winds over, leave it for 15 minutes come back fires up perfectly. Done this around 5 times now. Strange shit !
Next one is we cannot get the aircon to work, we've exhausted all of our options except maybe changing the dash wiring loom ?
Thanks again for the help guys.
Any fault codes? Flashing lights when you try cranking the car?
nothing more then normal, just got the opcom i'll see if it sheds some light
Crankshaft sensor will be the most likely for long crank issue.
You didn't let any AC gas escape by any chance? Clutch engaging when AC turned on?
nah clutch not engaging, took it and got it as much gas as my machanic could put in it without it starting. So deffinately electrical i recon
Did you use the compressor from the SRI? Common for the thermal fuse in the clutch to fail on the 1.8.
nah same one as on the combo. left it all in tact.
Now we have another problem. We plugged in the opcom unit, turned off the abs as we thought this was correct. However now the car wont start at all with abs enabled or disabled - wont work plugged in or unplugged. Anyone have any ideas on this one ?