Removing the front headlight in a 3dr AH

[dr600]

Hey guys, i want to install a LED strip inside my front headlights and i am finding it hard to remove casing because i need to get in there to mount the LED strip!

If anyone has a how to, or can tell me the best way to go about it, it would be very helpfull!!!

Thanx heaps!!!

Dave

P.S I can post some pics up when its done, should look good!!!

[MatsHolden]

If you are meaning you need to remove the lense from the housing, then you need to melt the sealing glue. People have done this with Corsa headlights by placing them in the oven on low heat for a short while to melt the glue.

[BEK-46P]

I too want to know how to do this!

[AH Sri Turb04]

+ 1

I want to know too :D

[AH Sri Turb04]

Steps:

(1) Remove headlight
(2) open, and seal headlight and re-connect


I would suggest the following steps for (1):

(a) Remove front grille (4 torx screws on slam panel, 6 clips on bumper)
(b) drop the front bumper (DONT KNOW HOW TO DO)
(c) remove head light (3 screws - 2 above the headlight and 1 at 90 degrees under the car)

If someone can fill in (b) that would be great start...

[moose_factor]

Steps:

(1) Remove headlight
(2) open, and seal headlight and re-connect


I would suggest the following steps for (1):

(a) Remove front grille (4 torx screws on slam panel, 6 clips on bumper)
(b) drop the front bumper (DONT KNOW HOW TO DO)
(c) remove head light (3 screws - 2 above the headlight and 1 at 90 degrees under the car)

If someone can fill in (b) that would be great start...

To take off the front bumper,

1) Take off the 2 torx screws in the wheel arch (2 per side)
2) Then it's all a matter of unclipping the bumper off the car (start with the side's going into the middle)