View Full Version : calibra brake lines - how do i undo this?
poita
13th November 2008, 12:10 PM
http://i37.tinypic.com/2q2fpd5.jpg
its a small bracket that holds the brake lines.
cant undo the fukin thing.
hhhhhhhhhhhhhheeeeeeeeeellllllllllllpppppppppppppp
poita
13th November 2008, 12:13 PM
bit more info
blue bit is lose, no problem
red bits seem to be joined butno matter what i have tried will not undo.
they just free spin.
the new piece to go on doesnt have a thread, it looks like it clips into the top red piece from underneath
http://i38.tinypic.com/x1exlj.jpg
this is the bit that will replace the bottom red 'nut'
http://i34.tinypic.com/28kj52v.jpg
auzvectra
13th November 2008, 12:19 PM
there is a clip holding it there :p.
see that bit of metal facing the can between the arrows, it's a turn up from the clip, et a screwdriver between it and the hose n the clip should come out, then the whole thing slides back thru the hole ;).
auzvectra
13th November 2008, 12:20 PM
soz, between the red arrows ;)
poita
13th November 2008, 12:22 PM
will let you know how it goes, thanks matt
auzvectra
13th November 2008, 12:26 PM
it might be a lil harder to get off "if" you managed to turn that nut a lil, as it may have burred the clip, but yeah should basically slide off, n that new 1 will replace the whole thing, the bit with both red arrows, it's just shorter, the lil recessed bit on the new 1 is where that clip locks into ;).
i'm sure u'll get it easy enough :p.
poita
13th November 2008, 12:40 PM
ur a champ :) got it off
any tricks for the back b4 i tackle it
poita
13th November 2008, 12:56 PM
thanks mate, 3 more to go :)
http://i38.tinypic.com/zmmtt1.jpg
SSS_Hoon
13th November 2008, 01:11 PM
are they ADR approved lines?
how much where they and where from?
SSS_Hoon
poita
13th November 2008, 01:13 PM
funny you ask that, calibrated jsut asked the same thing.
they are from goodridge in the UK.
afaik they are ADR and CAMS approved
SSS_Hoon
13th November 2008, 01:21 PM
oh ok goodridge make some decent lines, although they make ADR and non ADR lines also though so just double check that they are the ADR ones.
I think that there should be some stamp/tag on them if they are ADR approved lines..
SSS_Hoon
Powered by vBulletin® Version 4.2.4 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.