Handbrake Lever

[ZC_74]

Well, I got all my Richbrook stuff yesterday. Very nice. Will put up some pics when done.

However, can anyone tell me how to remove the handbrake lever and therefore the cowling that sits behind it.

Cheers

[ope126]

Mate I have the Holden Service & Repair Information on 4 CD's for the Vectra. Maybe it shows a break down oft hose areas which might assist, then gain maybe not.

I have not searched it close enough to date.

Other than that try www.vectra-c.com

There should be plenty of "How Too's" on there.

Glenn

[ZC_74]

Glen

I have tried vectra-c but to no avail so far

I would like to get my hands on a copy of those discs though

Cheers

[guy 27]

I dont know if its like the astra one but if it is use a soldering iron to cut it off.

[OPC]

i used multi-grips to get my astra one off...

sure it ruins the old one but why would u need it ?

[bornwild]

So how do you put the new one on if you need to destroy the old one to get it off?

[ZC_74]

The Richbrook is tubular and has a foam pad that goes around the origina lever left after the cover is removed and there are grub screws to keep it in place.

[ZC_74]

i used multi-grips to get my astra one off...

sure it ruins the old one but why would u need it ?

Mohawk

was there a fair amount of effort to pull it off

[OPC]

Mohawk

was there a fair amount of effort to pull it off

oh yeah... just twist and pull

bornwild: the irmscher lever was tubular so it went straight back over where the old one was...
then to keep it on it came with some thick black sticky crap

[ZC_74]

I still seem to be struggling to get this thing off.